within the Motherboards, Bios & CPU forums, part of the Tech Support Forum category. When starting up, I get the: 'Verifying DMI Pool Data ..................' message Just installed a new HDD on a system.
Make sure ALL cables are 100% connected to the system and are not loose at any scale.
If any of the above does not work then try and reset the CMOS using the CMOS jumper.
When we get this information and know that it is set up properly, then we can explore how you might address this issue. Its not where you make 3 boot selection but its another boot option.. On my M/B i select 3 boot devices but if i have multiple HDD's another boot option appears..
Ive had this problem once when i flashed my BIOS... So instead of having to select HDD0, HDD1 or HDD2 ect...
During bootup my computer hangs at "Verifying DMI pool data." What is it and how do I fix it? DMI or Desktop Management Interface (pdf) is a layer of abstraction between system components and the software that manages them.
The System Management BIOS (SMBIOS) is an extension of the Basic Input Output System (BIOS) that formulates and delivers this information to the operating system. In short, when the BIOS is "Verifying DMI pool data" it is verifying the table of data it sends to the operating system (Windows, etc.). Before replacing any hardware, we first recommend you erase everything on the hard drive and start over.If you're unable to reinstall the operating system your computer may have a hardware issue and it's suggested that the hard drive be replaced.Also, are you sure you are using an 80 connector cable and not one of the old 40 connector cables?Hello, I pressed something at the start of login once, something like y/n sata to dmos or something im not really sure but i pressed yes and now im getting verifying dmi pool data, update new data to dmi!The system then hangs, and I cannot do anything about it. Joel Hi, Go into your BIOS and make sure that the hard drive with the Windows installed is correctly set as the primary boot device.